STAGES OF CONSTRUCTION OF THE PYRAMID COMPLEX NEAR TOMSK CITY IN SIBERIA

PHASE 1

After completion of the surveying of the terrain of the future complex and the determining of the location of the pyramids, workers began with the excavation of the foundation pit for the central pyramid, the parameters of which will significantly differ from the parameters of the experimental pyramid near Priozersk city.
After completion of the surveying of the terrain of the future complex and the determining of the location of the pyramids, workers began with the excavation of the foundation pit for the central pyramid, parameters of which will significantly differ from the parameters of the experimental pyramid near Priozersk city.
The supply to the construction site of white quartz sand, originating from a deposit located in the vicinity was started. This mineral is of fundamental importance in the construction of pyramids because of its special properties, therefore all concrete work will be carried out using white quartz sand only, instead of the conventional yellow type.

White quartz sand is needed to enhance the properties of a pyramid and its ability to gently affect the energy structure of the human being as well as the space surrounding the pyramid.
The supply to the construction site of white quartz sand, originating from a deposit located in the vicinity was started. This mineral is of fundamental importance in the construction of pyramids because of its special properties, therefore all concrete work will be carried out using white quartz sand only, instead of the conventional yellow type.

White quartz sand is needed to enhance the properties of a pyramid and its ability to gently affect the energy structure of the human being as well as the space surrounding the pyramid.
The floor of the over 5 meters deep pit was covered with a layer of white quartz sand and compacted to form a basis for the concrete slab.
The floor of the over 5 meters deep pit was covered with a layer of white quartz sand and compacted to form a basis for the concrete slab.
On top of the subbase wire reinforcement was placed and the pouring of the slab began.
On top of the subbase wire reinforcement was placed and the pouring of the slab began.
The slab was then covered with a dual-purpose waterproofing coating. Apart from the water seal it will act as an energy filter.

The composition of the coating was supplemented with minerals that affect the speed of energy processes to accelerate the ascending energy flow from the Earth.
The slab was then covered with a dual-purpose waterproofing coating. Apart from the water seal it will act as an energy filter.

The composition of the coating was supplemented with minerals that affect the speed of energy processes to accelerate the ascending energy flow from the Earth.
Upon completion the slab has received the shape of an octagon, on which the 12-sided foundation will then be cast.
Upon completion the slab has received the shape of an octagon, on which the 12-sided foundation will then be cast.
On this foundation a 12-sided resonator several meters in height will arise, on which the pyramid of the project will be standing.
The decision to place the pyramid on a 12-sided foundation was dictated by the need to filter out the negative component of the energy flow coming up from the Earth.

Problem is that any place of power, any energy flow coming from the Earth, has a certain negative component. This factor has always to a greater or lesser extent (depending on the power of the flow) had a negative impact on people, especially in the development of parapsychological and extrasensory abilities. In fact, this is one of the most serious problems very negatively affecting the process of human evolution. So far only very few thought about the causes of these negative effects. However, in the monuments of antiquity mentions and even certain technological solutions to this problem have been preserved.

In ancient times, a special 12-sided resonator was used, and we decided to build such one to neutralize (cut off) this negative component of the energy flow coming from the Earth.
The new pyramid will significantly differ from its predecessor (the experimental pyramid). In it, much will be different, first of all, the width of the pyramid base, the thickness of the walls as well as the insolation of the entire structure which is of extreme importance in northern latitudes, where there are considerably more cold than warm days and will allow for a comfortable working in the pyramid.

The wall thickness of the 12-sided foundation as well as of the pyramid exceeds that of the experimental pyramid by 2.5-fold. Along with the anchoring of the wall reinforcement several layers of insulation were placed.
Next, the construction workers began to mount a special metal formwork.
Such formwork will allow the walls of the 12-sided foundation to be cast with the highest level of precision.
After completion of the walls of this 12-sider, the deviation between the two opposite faces is less than 5mm! Measurements were carried out using special laser equipment.

Having obtained the measuring results, work began on finishing and polishing the surfaces of the walls of the 12-sider.
After finishing the surface polishing, the outer walls of the 12-faceted foundation were covered with a special composition, which increases the inward flow-rate of energy into this 12-sider. This is important for obtaining a high energy flow density, which opens up in the human being the ability, for example, to telepathically perceive information.
In parallel, inside this 12-faceted foundation an energy source was installed with an energy-capture-zone, a vortex, up to 33 meters in diameter!

This energy source is based on a large quartz crystal. The crystal was chosen for its energy qualities. Of great importance is that the crystal structure over millions of years of its growth has formed in a zone of high energy density. This means that to create an energy source you need not just a crystal, but a crystal grown in a special place of power, where the energy flow has certain properties.
The crystal should be large enough so that its crystal structure (chakra), which effectively fulfills the role of converter, emits a sufficiently powerful energy flow.
Then the manufacture of the formwork for the Oracle chamber began. This chamber is located in the center of the 12-faceted foundation underneath the pyramid and will perform several functions.

Firstly, the stabilization of the energy flow generated by the pyramid. As radar observations show, the energy flow generated by a pyramid is not stable during solar and magnetic storms. During such periods the height of the energy column above a pyramid fluctuates, constantly changing in height. The height of the energy column though is a direct indicator of the effectiveness of a pyramid. In some cases, during powerful magnetic storms it simply disappears. To stabilize this flow, it is necessary to build a special 8-sided resonator.

Secondly, by concentrating and condensing the energy flow, the oracle chamber creates a field through which the human consciousness can connect to the Earth's information field to obtain information about the past, present and future. That is why we have called this chamber according to ancient tradition oracle chamber.
In addition to the above-described functions, this chamber will be the cover for the central crystal of the pyramid's energy system.
After the energy source was installed and protected by a concrete slab, the erection of the load-bearing walls began, on which the 12-faceted ceiling plate will then be cast.

The configuration of these load-bearing walls is designed so that with a minimum of those the 12-faceted ceiling will support the weight of the pyramid, which later will be standing on this 12-sided foundation.
Preparation of the formwork for the concrete ceiling. In the center, the passage leading to the central chamber of the 12-sided foundation is clearly visible.

The entrance to the pyramid will not be on the side, as it was done in the experimental pyramid, but from below, through a side of the 12-faceted foundation below ground level. From the northern face of the 12-sider, through a long, high-ceiling corridor one will get into the central area of the 12-sided resonator, with the oracle chamber located there, and further via a separate side staircase into the pyramid itself.
Preparation for pouring the ceiling slab.
The beginning of a responsible operation – the pouring of the ceiling slab. Everything must be exactly level, with observance of the given height for the 12-sider (dodecagon).
Simultaneously, the filling of white quartz sand around the 12-sided foundation began.
After completion of the ceiling slab it was covered with a waterproofing coating with an admixture of minerals. The boarded outlets on the surface are the air shafts, which will later allow for natural ventilation of the pyramid's internal chambers via bottom-up airflow. This is very important for the future health of the concrete walls and ceilings.
Details about the ideas and principles embodied in the world's first pyramid complex in Tomsk can be found in the book "Pyramids. Legacy of the gods" by Valery Uvarov.
All rights to the content of this site belong to
Valery M. Uvarov

The use of this content or part of the content from this site in any way
other than personal acquaintance is possible only with the written
permission of Valery M. Uvarov
All rights reserved
© 2017 All content on this site is protected under copyright
Contact us
If you have any questions do not hesitate to ask, filling in the form below.
+7 901 301 81 07
+7 964 333 29 36
St.Petersburg, Moscowsky pr. 78-2